EM-71

ENGINE MECHANICAL - Cylinder Head (3S-GTE)

EM-61  EM-62  EM-63  EM-64  EM-65  EM-66  EM-67  EM-68  EM-69  EM-70  EM-71
em8079.gif (16267 bytes) 39.  REMOVE CAMSHAFTS
Uniformly loosen and remove the ten bearing cap bolts in several passes in the sequence shown, and remove the five bearing caps, oil seal and camshaft. Remove the intake and exhaust camshafts.
em78608037.gif (34163 bytes) 40.  REMOVE CYLINDER HEAD
(a)  Using SST, uniformly loosen and remove the ten cylinder head bolts in several passes in the sequence shown.

SST 09043-38100

HINT:  Cylinder head warpage or cracking could result from removing in the incorrect order.
em8878.gif (12517 bytes) (b)  Lift the cylinder head from the dowels on the cylinder block, and place the cylinder head on wooden blocks on a bench.

HINT:  If the cylinder head is difficult to lift off, pry between the cylinder head and cylinder block with a screwdriver.

NOTICE:  Be carefull not to damage the contact surfaces of the cylinder head and cylinder block.