EM-67

ENGINE MECHANICAL - Cylinder Head (3S-GTE)

EM-61  EM-62  EM-63  EM-64  EM-65  EM-66  EM-67 EM-68  EM-69  EM-70  EM-71
em8973.gif (23275 bytes) 25.  REMOVE WATER OUTLET AND HOUSING
(a)  Disconnect the following connectors:
      - Water temperature sender gauge connector
      - Water temperature sensor
      - Cold start injector time switch connector
(b)  Remove the bolt, and disconnect the fuel inlet hose.
(c)  Remove the bolt, and disconnect the fuel return hose.
em9051.gif (24676 bytes) (d)  Disconnect the following hoses:
      (1)  Water filler hose
      (2)  Radiator hose
      (3)  Water by-pass pipe hose from ISC valve
      (4)  Heater water hose
em9052.gif (22801 bytes)       (5)  Water by-pass hose from water by-pass pipe
      (6)  Two EVAP VSV vacuum hoses.
em8970.gif (26060 bytes) (e)  Remove the two bolts, the water outlet, housing assembly and gasket.

26.  REMOVE OIL PRESSURE SWITCH

27.  REMOVE OIL COOLER
      (See steps 7 to 10 on pages LU-18 and LU-19)
em8917.gif (20977 bytes) 28.  REMOVE WATER BY-PASS PIPE
(a)  Disconnect the following hoses:
      (1)  Water by-pass hose from cylinder block