(See page BO-29)
1. CLEAN MOULDING MOUNTING
SURFACE
Wipe off stains with cleaner.
Using a heat light, heat the body mounting surface to 30-50�C (86-122�F).
NOTICE: When the moulding is installed, the temperature of the mounting surface should be 20�C (68�F) or higher.
Using a heat light, heat the moulding to 30-60�C (86-140�F).
NOTICE: Do not heat moulding excessively.
The temperature should not be higher than 80�C (176�F).
Apply adhesive to both punched out ends of the moulding.
NOTICE: Install the moulding within 7 minutes after applying the adhesive.
NOTICE: When the moulding release sheet is removed, be sure that no dirt or dust can get onto the uncoated area.