BO-30

BODY - Moulding

<<previous

next>>
REMOVAL OF SIDE PROTECTION MOULDING

(See page BO-29)

1.  REMOVE FRONT FENDER OUTSIDE MOULDING
(a)  Using the clip remover, remove the clip from the moulding.
(b)  Pull off the moulding by cutting the adhesive with a knife.

(See step 3 on this page)

2.  REMOVE ENDS OF MOULDING
Using a scraper, pry the moulding loose about 30 mm (1.18 in.) from the ends.

HINT:   Tape the scraper tip before use.
3.  REMOVE MOULDING AND ADHESIVE
(a)  Pull off the moulding by cutting the adhesive with a knife.
(b)  Scrape off adhesive from the body with a cutter of sandpaper.

HINT:   Tape the scraper tip before use.

 

4.  REMOVE DOOR OUTSIDE MOULDING
5.  REMOVE QUARTER OUTSIDE MOULDING
Remove the screw and the moulding.

6.  REMOVE QUARTER AIR INLET GARNISH
(a)  Remove the nut.
(b)  Insert the screwdriver between the garnish and the panel to pry out, and remove it.

HINT:   Tape the screwdriver tip before use.