LUBRICATION SYSTEM - Replacement of Engine Oil and Oil Filter

REPLACEMENT OF ENGINE OIL AND OIL FILTER

1. DRAIN ENGINE OIL
(a) Remove the oil filler cap.
(b) Remove the oil drain plug, and drain the oil into a container.

 
lu1081.gif (19800 bytes) 2. REPLACE OIL FILTER
(a)  Remove the air duct from the alternator.
(b)  Using SST, remove the oil filter.

SST 09228-06500
lu1007.gif (20432 bytes)
lu0498.gif (10434 bytes) (c)  Check and clean the oil filter installation surface.
(d)  Apply clean engine oil to the gasket of the new oil filter.
lu0490.gif (13175 bytes) (e)   Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
(f)   Using SST, tighten it an additional 3/4 turn.

SST 09228-06500

(g)  Reinstall the air duct to the alternator.
3. FILL WITH ENGINE OIL
(a)  Clean and install the oil drain plug with a new gasket.

Torque:  3S-GTE   200 kg-cm (14 ft-lb, 20 N-m)
              5S-FE       400 kg-cm (29 ft-lb, 39 N-m)

(b)  Fill with new engine oil.

(c)  Reinstall the oil filler cap.

4. START ENGINE AND CHECK FOR LEAKS

5. RECHECK ENGINE OIL LEVEL (See page LU-6)