BO-34

BODY - Moulding

<<previous

next>>

(b)  Remove six screws.
(c)  Insert the screwdriver between the moulding and the panel to pry out.

HINT:  Tape the screwdriver tip before use.

(d)  Pull the moulding upward to remove it.

NOTICE:  Do not damage the body.
INSTALLATION OF BACK WINDOW MOULDING

(See page BO-33)

1.  INSTALL BACK WINDOW MOULDING
(a)  Tap the moulding and fix it in place with the clips.
(b)  Install six screws.

 

(c)  Install five nuts.

2.  INSTALL FOLLOWING PARTS:
(a)  Roof side inner garnish
(b)  Seat belt shoulder anchor
Torque:  440 kg/cm (32 ft-lb, 43N-m)
(c)  Quarter trim panel
(d)  Room partition trim moulding
(e)  Roof headlining rear trim
(f )  Door scuff plate
3.  INSTALL ENGINE HOOD SIDE PANELS
Install two panels with four screws.